Bilge Pump Non Return Valve One Way Outlet 25mm or 38mm Hose Back Flow Tamper Torx Socket Bits

Bilge Pump Non Return Valve One Way Outlet 25mm or 38mm Hose Back Flow Tamper Torx Socket BitsPrevents back flow of water in the bilge. Mounts as close to the strainer as possible and lock up water in the hose. Straight through design. Top quality polyamide valve + nitrile gasket (fuel resistant) Suitable for 25mm (1in) or 38mm (1. 5in) internal diameter hose by sawing off the 25mm outlets if needed. A pre moulded groove indicates where to cut. An essential safety feature on some bilge pump installations. Sizes 185mm total length (with 25mm

5cm wide and 23cm high

Therefore compatible with most road vehicles

• Total width – 30mm (each side of the hinge)

Fitted with long handle for restricted access

This listing is for 4 brake cable domed nut

Also provides a variable control for when this is required

Also includes the required triangle rear retro reflectors

Simple to use simply select the pipe size put the equivalent formers and then pulls along a coiled tube of brake pipe to straighten it

Suitable for one handed pipe cutters / slicers ranging from 15mm – 28mm

Suitable for 24mm diameter rope

This listing is for a pack of 5 male to male threaded Union Fittings

Also serves as white / clear retro reflectors when not lit