Phaetus PH Hardened Steel Nozzle 0.4/1.75mm (PH-HS-NOZZLE-0400) B00FZPHMUG

Phaetus PH Hardened Steel Nozzle 0.4/1.75mm (PH-HS-NOZZLE-0400) B00FZPHMUGBrand: PHAETUS Features: Hardness over HRC60 makes an minimum wear at the hole size after a long time printing with abrasive materials. Temperature resistance up to 450, easily handling with special engineering plastics such as PEEK. Special processing technology and post treatment make the nozzle without burr at the edge of tip and without debris in the hole. Inner hole roughness lower than Ra0. 4; Higher smoothness and less adhesion. Min. orifice

PartNumber: MK8-NOZZLE-0800

4 and the whole nozzle nickel plated

There is an additional version – with mount for a filament sensor – that is compatible with the CR-10S (equipped with filament sensor)

Use our small nozzle orifices to achieve fine details or larger nozzle orifice sizes for more substantial

EAN: 0814358016206

Model: Push-pin

and other printers that uses the same type of mounting plate will replace the original feeder

UPC: 814358016084

The smaller nozzles have a small nozzle tip which offers incredible precision

This kit includes a Hemera heatsink with a revised design that’s compatible with a Revo HeaterCore and Revo Nozzles

however the reverse may cause irreversible damage

5x lifespan boost