1/2X6X96FSB Shims

1/2X6X96FSB Shims1 2" x 6" x 96" Flat single bevel, weld on cutting edge. Good to weld under the front edge of your bucket to give it a wear surface or to replace the front lip of your bucket. If it becomes the new front lip of your bucket you can drill or blow holes in it to match a bolt on edge if you like.

This is a 35pn pin for use with 35s series bucket teeth

This is the replacement bolt on reversible cutting edge for our 72" skid steer bucket

Also known as 198-1092

This is a cat j400 series style single tiger bucket tooth with industry standard part number of T7t3402L also 159-0400

This is a V51pn Esco style Super V pin

This is a cat j460 series style weld on adapter with industry standard part number of 8e6464 also 159-0464

the legs of the angle are 6" & 4-1/2" and it is about 4-1/2" wide

It is typically found on a standard highway punched snowplow that is 108" long with 11 holes

This tooth uses pin 2mg8upr also known as mg8upr

It is 5 mm thick with an OD of 90 mm

This bolt on side cutter (can be welded on) is for loader buckets and has an industry standard part number of 253-0065 and are for Caterpillar 966-973 models

5" wide and has an industry standard part number of f150ws