Dyna Copper Core Silicone Wire, 7mm, Red Harley Davidson

Dyna Copper Core Silicone Wire, 7mm, Red Harley DavidsonBuilt to give you a better burn, a more powerful spark and better throttle response, upgrading to Dynateks Dyna Wires will allow you to tap into max performance when you need it most. All wires are supplied with finished spark plug boot ends and loose coil terminals to allow the final length to be determined by the user. Wires are available with a solid copper core for use on older vehicles where electrical interference is not an issue. For use on new

Higher rev limit

spark plugs wires and all necessary mounting hardware

providing the strong spark needed to develop peak power for turbocharged

The Twin Fire coil is only slightly larger than the stock Harley coil and uses the stock mounting bracket

Works on 1-4 cylinder engines

check the coil primary resistance requirements as specified by the manufacturer of the ignition being used

High voltage and primary terminals machined from brass

the battery voltage is getting very low and the charge circuit or battery is failing

There are also 2 user-programmable RPM outputs that can be used to activate a shift light or other RPM activated device

Make your quad the best it can be by rising above stock performance and installing a Dyna FS module

For use on new vehicles with electronic advance ignitions

Plug-in module replacement for easy mounting